Quiz on Destructive testing Welcome to your Quiz on Destructive testing 1. The mechanical / Destructive test of pipe inspection confirms the mechanical requirements of pipe are as per the material standard True False 2. In Destructive Testing- a sample from the pipe is cut to performed tests True False 3. Which of the following test is done to check the yield and ultimate tensile of the pipe Tensile Test Bend Test Flattening Test Impact test None of the aboe 4. Which of the following test is used to check the integrity of weld joint Tensile Test Bend Test Flattening Test Impact test None of the aboe 5. Which of the following test is used to check ability of plastic deformation in a pipe Tensile Test Bend Test Flattening Test Impact test None of the aboe 6. Which of the following test is used to check the ability of a material to withstand under low-temperature conditions Tensile Test Bend Test Flattening Test Impact test None of the aboe 7. Which of the following test is used to check the long-term effect of temperature under constant load Tensile Test Bend Test Flattening Test Impact test Creep test 8. In Tensile Test, The stress obtained at the highest applied force is the Tensile Strength True False 9. Tensile Tests are performed as per ASTM E8, ASTM A370, ASTM B557, IS/ BS Standard All of the above 10. The bend test uses a coupon that is bent in three points bending to a specified angle. True False 11. Impact Test is to determine whether the material is brittle or ductile in nature. True False 12. What the types of Creep tests tensile creep, compressive creep, flexural creep, indentation creep All of the above 1 out of 6